O) Bed
Step 1 — Assemble the Bolt Stacks for Attaching the bed
- It works best to build the bolt stacks for attaching the bed, then put them in place on the yokes.
- (Filastruder kits use a Socket Cap Head Screw in place of a button head bolt)
- On a 20mm Button Head Bolt place:
- (1) M3 Fender Washer
- 1/4 rubber washer
- (1) M3 Fender Washer
- (1) m3 Nylock Nut
Step 2 — Put Bolt Stacks on the Yokes
- Place the bolt stack on the yoke, so the Nylock nut and m3 fender washer are below the Yoke, and the 1/4 rubber washer is on top of the yoke.
- Repeat for all 3 yokes.
- Note The right yoke gets a ground wire from the bed wiring harness above the top washer. (not yet pictured). This requires a 25mm bolt to do as shown, currently the kits ship with only 20mm bolts, leaving out the lower washer is temporary fix.
Step 3 — Install Bed
- Install the bed by fitting it onto the yokes, with the best resting on the 1/4 rubber washers, and the m3 fender washer in the grooves on the bed tabs.
- Snug up the m3 nylock nuts to hold the bed in place.
Originally at https://railcore.dozuki.com/Guide/O)+Bed/14